Member Discussion Forum

Hello every one,our company focus on furnace repair.But nearly we struggle on creating new repairing methods. usually we do repair by ceramic welding against any glass furnace damage. However it cannot apply to ever furnace. So I am here to find new repair method. Any useful methods will
be very appreciated.

Shanghai tengwang new ceramic Co.Ltd
Greg
wyd-greg@hotmail.com

Hi,
I am hoping to order laminated glass (most likely from China) and this will need to be stamped EN14449 and EN356 P1A ? The glass should be 6.8mm thick and meet these European standards. Can you recommend a reliable glass supplier that has passed these tests and can email me certificates?

Kind Regards,

Jeremy.

fangding eva film is produced with 100% fresh material.The transmittance of super transparent film can reach 90%.Here are our three types of eva film,indoor decorative glass film and solar PV panel laminated glass film.EVA film for out door use is excellent in high UV-blocking and longer useful life.

Fangding eva film is mainly used for curtain wall, skylight ,interior decoration,shower room,hotel kitchen&bath decoration,indoor partition,solarr PV panel,PDLC/LED laminated glass, coffee table,ect.

Does anyone know of a method for detecting holes in glass-ideally a fairly compact device.

i need for one website online shopping for glass tools accesories. who can find something for this question please...?

Hi,

I am after some PVB off cuts in small quantity of around 200-300 kgs. Coudl someone provide me with some contacts where I might be able to get some please. I require them to be in uncompressed form.

Thanks in advance.

Kind regards,
KG

hi,
I am learning about anticondensation on glass in buildings. I want to know the reason cause the anticondensation on glass and the clearance or solution for this problem. You can provide information for me? Thanks very much

For the glass point fixed installation ( spider system) Which type of glass is suitable? is it the Temper glass ( with Heat soaked) or just Heat Strengthened is enough?

We have a piece of 10mm tempered glass sized 1x2 meter and it was chipped about 10mm into the glass and about 1 meter along the edge. Our machine had been tested to temmpered glass to meet TUV standard. Does it mean that my glass is not fully tempered or it is the nature of tempered glass? Thanks to the experts.

I have made some solar hot water panels but am having problems with mist forming on the glass when the inside becomes hot. I am seeing a mostly dry deposit (a little greasy in areas) causing a misting. This only occurs when the temperature inside is >100 Deg C (max I have measured is 130 Deg C).

I was wondering if the problem may be agrevated by coatings on the glass, does anyone have any thoughts?

Would it be possible to remove any coatings by polishing with jewlers rouge (if it would help)?