Possibility for re-analyse with LineScanner

This works for dimension- and quality check.        

It means, that the system checks the quality and/or size of a glass according predefined quality settings. If the operator recognizes, that the used quality set is not the correct one for this specific piece of glass, he can change the quality set and ask for a re-analyse of it. The result in reference for the new quality set will be shown immediately to the operator.

Next to this, the glass can now also be checked according 2 different quality sets every time. This results in the usage of 2 output signals. The first one could be used e.g. for an automatic stapler to remove the “bad glasses”, while the second result is going to be shown to an operator on a typical stop-position on the production line.

chips

chips at edge of glass

drill hole

drill hole broken

scratch

scratch on glass