Member Discussion Forum

Hello everyone) I recently brought a glass printer for work(Tecglass Vitro-jet) and got some troubles setting it up. I also didn't manage to understand all the settings of Epson WorkForce Pro printer, which I purchased for home activities.The details of my equipment: https://www.bestadvisor.com/best-all-in-one-printers . If someone would like to help me out, please contact me via PM or through this forum thread.

Hi, 

We need advice with a frameless glass balustrade we have been asked to supply and install. 

Job is in qld, Australia.  

Glass, 12mm toughened. Fix to slab with 2 x core drill stainless steel spigots. Handrail to bolt through glass and tie into walls. 

The developer and architect want the finished glass height to be 1350mm . 

The spigot supplier only has calculations to a glass height of 1200mm. 

We are in need of someone to advise or calculate if we can go to 1350mm high. 

Hi!

There are big windows in my new office with small scratches on them. I want to buy a window cleaning robot. 

1) I don't know which one to choose. These are my variants https://www.bestadvisers.co.uk/window-cleaning-robot, but I open to any other suggestions ;)

2) Can I use a robot, when I have scratches on the windows? Won't it make situation worth? 

Thank you for your time and ideas!

I am in search of a document, preferably ASTM or similar, that outlines:

• the tolerances for IG units in regards to spacer alignment, in terms of the straightness of the spacer along any given length for foam spacers, and
• the parallel alignment of spacers in triple IG units

If anyone knows where I can find this information, I have about exhausted my search online.

Thanks.

Hi All,

We developed two different technologies for Fluorides removal in acid etching glass. We are open to exchange experiences in this topic.

Dear All

I have installed a laminated glass floor - made out of three glass panes of 15mm each.  On installation there were no defect. After 4 months air bubble like defects started developing between the layers of glass, at different levels - that is some between the upper and middle layer - others between the middle and lower layer. 

What could be the reason for this?

Thanks in advance

We are looking for a supplier of the above product. Does anyone know where you can get it in the UK?

Information sharing about switchable glass and pdlc film from how it is made,its history, application,market trends or more..

Does anyone have scientific data whether tempered glass surface stress is reduced after heat soak testing