Pannkokes focus nowadays is the production and development of semi-automatic cutting tables as well as the entire range of vacuum technology and tools for the glass processor.
With a representative selection of the wide range of lifting devices, Pannkoke would like to give you ideas for the application and use of vacuum lifting devices at glasstec 2002.
On display will be:
·rechargeable battery-operated devices for the construction site
·mains-operated devices for the processing company
·compressed air-operated devices for manipulating within the company
·special glazing devices for the construction site
·devices for car and bus glazing
Vacuum lifting device BALANCE
For glazing under a roof projection of ca. 1500 mm and a weight of 1000 kg.
BALANCE has a movable counterweight. The travel movement works via a rechargeable battery-operated direct current drive which is equipped with a speed control for fine adjustment of the inclination movement. With an available retrofit kit it is also possible to transport curved facade elements with the vacuum lifting device.
Vacuum lifting device 7201-HVSO
At the installation of a new office block, totally new standards in facade technology were set with the help of a newly-designed vacuum lifting device, 7201-HVSO, from Pannkoke. Using this new mounting technique for the steel-glass facades in element construction, up to 60 m² large mega-facade elements were installed directly at the construction site, completely glazed and equipped with inset elements. These facade elements were installed with the Pannkoke vacuum lifting device 7201-HVSO in the building in pre-assembled anchorage consoles in less than 15 minutes. The entire mounting time, in comparison to conventional mounting, is reduced by approximately one third - and this without a cost-intensive scaffold for the building.
Range of products
* Machines for cutting flat glass
* Vacuum lifting devices for handling and transport of flat glass
* Tools and devices for flat glass processing
Pannkoke
Flachglastechnik GmbH
Haendelweg 5
D 23556 Luebeck
Tel: +49 451 47008 0
Fax: +49 451 47008 37
E-mail:info@pannkoke.de
Pannkoke Flachglastechnik GmbH
Hall 15Stand A31 + A35The company Pannkoke Flachglastechnik GmbH is one of the oldest producers of devices for glass processing and since the beginning of glasstec, an exhibitor in Duesseldorf.